1 | Before You Begin
Remember or write down the SSID (Service Set Identifier) and Password mentioned in the battery compartment before inserting the battery and replacing back cover.
You will need it to set up your device.
You will need it to set up your device.
2 | Inserting SIM Card & SD Card
Open the back cover and locate the SIM and SD Card slots. Slide the SIM and SD trays downwards (OPEN) to lift the trays up. Then insert the SIM and SD Cards and slide the trays upwards (LOCK) to secure the tray. Make sure both the SIM and SD Cards are placed properly with the chip facing down.
3 | Turning on the Device
The setup is complete. Now you can turn ON your device by pressing the Power Button and connect your device to the wireless network by using the SSID and Password you noted down in Step 1.
Hold the power button for 3 Seconds to turn the device ON/OFF. You can connect up to 12 Wi-Fi enabled devices at the same time on your Jazz Wi-Fi Device.
4 | The Wi-Fi Push Setup
The Wi-Fi Push Setup (WPS) Key enables you to connect to the device without entering the password.
Simply press the WPS Key for 3 seconds and then press the WPS button on your mobile phone, tablet or computer.
5 | Charging the Device
When charging the battery for the first time, it is recommended to charge the device to 100% using the adapter and power cable provided.
Turn OFF the device when charging for better results.
Charging Time
USB Cable: Approx 7hrs
Power Adapter: Approx 3hrs 30 mins
Battery Time on LTE*
Stand by time: Approx 300hrs
Running time: Approx 6-7hrs
*Depends on network conditions
6 | Resetting the Device
Occasionally, you may need to perform a Hardware or Factory Reset if you forget your login username or password.
To reset the device, insert a small pin (such as a straightened paper-clip) into the Reset Button for 1 second.
7 | Web Configuration
Change Network Name, Password etc.
Using the Web Configuration Utility, you can change the Network Name (SSID), the Password, configure the Sleep Mode and modify other functions.
Step 1: Connect your Computer/Smartphone to the Jazz Wi-Fi device over USB or Wi-Fi interface.
Step 2: Enter the URL http://jazz.wifi in address bar of the browser to open the web configuration page
Remark: The system might enter sleep mode after some time of inactivity. In case the device goes into Sleep Mode press the Power Button lightly to bring it back to Active Mode. During Sleep Mode, the SSID of your Jazz Wi-Fi Device will stop broadcasting and a breathing light can be seen on the Power Button.
8 | Indicators
Signal Indicators:
No Network
2G
3G
LTE
Battery Indicators:
20% – 100%
Less than 20%
Comments
Post a Comment